Screen Functions23 DEVICE BACKUPSaves and loads the user settings to and from a USB flash drive.Use this function when you want to set multiple DZR, DXS-XLF series devices to the samesetting configuration, or change to another DZR, DXS-XLF series device while retainingthe same settings.q SAVE TO USBSaves settings data to a USB flash drive.Connect the USB flash drive to the USB terminal, and then select SAVE TO USB andenter the file name. File names can be up to 16 characters long. Only half-width alpha-numeric characters and some symbols are supported.Turn the main knob to select the position to enter text, and then press the main knob toenter text input mode. When in text input mode, turn the main knob to select a charac-ter, and then press the main knob to enter the character.w RESTORE FROM USBLoads settings files stored to a USB flash drive.Connect the USB flash drive to the USB terminal, and then select RESTORE FROMUSB. A list of files stored to the USB flash drive will appear on the screen. Select thefile you want to load. Up to 20 files can be displayed on the screen. DANTE SETUPThis screen is used to configure Dante settings and display the Dante network status.q MODE (DANTE MODE)Sets the mode used when connecting this product to the Dante network.• STANDARD: Select this when not using the TF series Quick Config function.• Quick Config: Select this when using the TF series Quick Config function.For more details on potential alert messages, see the “Message List” (page 37).• Audio will be muted temporarily when settings are changed to avoid noise being output.• For more details on potential alert messages, see the “Message List” (page 37).• When changing file names on your computer, make sure the new file name is 16 characters orless and only uses half-width alphanumeric characters or the following symbols: !, #, $, %, &, \',(, ), +, ,, -, ., =, @, [, ], ^, _, `, {, }, (space). Note that you will not be able to load a file that doesnot follow these naming conventions.• Be aware that using RESTORE FROM USB will overwrite presets even if they areprotected (see page 15, “ PROTECT”).qwNOTENOTEIf there are multiple TF series devices on the Dante network, only select the TF series “with OUT-PUT” check box for one device. Patches will not be applied correctly if multiple devices areselected.Dante modeluewrtyqScreen after scrollingdownwardsNOTE