Functions8 Dante Section!4 Dante jacksThese are etherCON jacks for connecting with Dantedevices and computers. The two jacks are primaryconnectors that can be linked in a daisy chain connec-tion (see page 29). This connection cannot be used ina redundant (secondary) network.!5 [LINK] indicatorShows the communication status of Dante jacks.Lights green when an Ethernet cable is connectedcorrectly to the Dante jack. This indicator will turn offautomatically when BLACKOUT is ON (see page 20).!6 [1G] indicatorThis indicator will light up in orange when the Dantenetwork is functioning as a Giga-bit Ethernet.This indicator will turn off automatically when BLACK-OUT is ON (see page 20).!7 [SYNC] indicatorLights steady or flashes green according to the Dantecommunication status, as shown in the following table.This indicator will turn off automatically when BLACK-OUT is ON (see page 20).Use STP (Shielded Twisted Pair) cables to prevent electro-magnetic interference. Make sure that the metal parts of theplugs are electrically connected to the STP cable shield byconductive tape or comparable means.This indicator may flash for 30 seconds when the power isturned on when connected to a network device.Dante model!7!4!5!4!5!6 !6NOTENOTESteady Operating normally as a clockslave on the Dante networkContinuously flashes Operating normally as a clockmaster on the Dante networkPeriodically flashesone time Incorrect DANTE FS settingPeriodically flashestwo timesDante network cable not con-nectedPeriodically flashesthree timesIncorrect Dante network con-nection