Components23adjuster lever is set to the “A” position. Check the tiller handle for smooth move-ment when the lever is turned to the star-board side “B”. Do not apply lubricants such as grease tothe friction areas of the steering friction ad-juster.EMU26143Power trim and tilt switch on remotecontrol or tiller handleThe power trim and tilt system adjusts theoutboard motor angle in relation to the tran-som. Pressing the switch “ ” (up) trims theoutboard motor up, and then tilts it up. Press-ing the switch “ ” (down) tilts the outboardmotor down and trims it down. When theswitch is released, the outboard motor willstop in its current position.For instructions on using the power trim andtilt switch, see pages 55 and 57.EMU26153Power trim and tilt switch on bottomengine cowlingThe power trim and tilt switch is located onthe side of the bottom engine cowling. Press-ing the switch “ ” (up) trims the outboardmotor up, and then tilts it up. Pressing theswitch “ ” (down) tilts the outboard motordown and trims it down. When the switch isreleased, the outboard motor will stop in itscurrent position.For instructions on using the power trim andtilt switch, see page 57.WARNINGEWM01030Use the power trim and tilt switch locatedon the bottom engine cowling only whenthe boat is at a complete stop with the en-gine off. Attempting to use this switchwhile the boat is moving could increasethe risk of falling overboard and coulddistract the operator, increasing the riskof collision with another boat or an obsta-cle.UPDNZMU03938
