Yamaha FJR1300A Service Manual

Also see for FJR1300A: Service manual Owner's manual Owner's manual Owner's manual Owner's manual

CABLE ROUTING2-461. Brake hose (front brake master cylinder tohydraulic unit)2. Right handlebar switch lead3. Clutch hose4. Left handlebar switch lead5. Main switch lead6. Immobilizer unit lead7. Left horn (low)8. Brake hose (hydraulic unit to left front brakecaliper)9. Front wheel sensor lead10. Brake hose (hydraulic unit to right front brakecaliper)11. Brake hose (metering valve to right front brakecaliper)12. Brake hose (hydraulic unit to front brake calipers)13. Right horn (high)14. Headlight relay (on/off)15. Radiator fan motor relay16. Main fuse17. Brake light relay18. ABS test coupler19. Positive battery lead20. Throttle cable (accelerator cable)21. Throttle cable (decelerator cable)A. Route the right handlebar switch lead under thehandlebar.B. Route the left handlebar switch lead under thehandlebar.C. Pass the clutch hose, right handlebar switch lead,and left handlebar switch lead through the guide.D. Route the main switch lead to the inside of theclutch hose.E. Route the immobilizer unit lead to the inside of theclutch hose.F. Temporarily tighten the brake hose joint bolt, unionbolt, and brake hose holder bolt in the propertightening sequence as shown. Then, tighten thebolts to the specified torques, making sure totighten the brake hose joint bolt “1” last.G. To front cowling wire harnessH. Install the horn L-shaped connectors so that theleads are routed outward.I. Fasten the grommet on the front wheel sensor leadwith the holder.J. Connect the coupler that has blue tape wrappedaround its leads to the radiator fan motor relay.K. Install the ABS test coupler completely onto thetab on the battery stay.L. Pass the brake hose (front brake master cylinder tohydraulic unit), right handlebar switch lead, andthrottle cables through the guide as shown in theillustration.M. Fasten the main switch lead and right handlebarswitch lead with a plastic locking tie at the locationshown in the illustration. Position the buckle of theplastic locking tie under the leads, with the endfacing inward, and then cut off the excess end ofthe tie.Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keysemail: info@motomatrix.co.uk