English3n Attaching the spikeWhen setting up the speakers on a thick carpet, use the spikesinstead of the stand. With 4 points set in place to achieveincreased stability and improvements in sound quality.Procedure:À Set the nut close to the tip of the spike and screw theminto the bottom of the speaker at each of the four specifiedholes.Á Place the speaker in the desired location in an uprightposition and adjust the length of the spike to match thedepth of the carpet. When adjustment is complete, twist the nut up to the baseof the speaker firmly.Notesl The tips of the spikes may scratch or otherwise damagethe flooring. Please be careful when positioning thespeakers.l If force is applied to the side of the speaker, it may falland damage the speaker or cause personal injury.Please be careful.HOW TO USE THE ACCESSORIES INCLUDED WITH THE SPEAKERSn Attaching the standWhen positioning the speakers, be sure to use the stand toincrease stability.Use the 8 specified holes located on the base of the speaker.Procedure:À Put the 6 mm screw through the inside hole on the stand.Á Place a washer on the screw on the speaker side of thestand and attach to the speaker at one of the outside holeson the base of the speaker.At this time, attach the stand so that it can still be movedslightly. Put the 4 mm wood screw through the outside hole on thestand, and screw into the inside hole on the base of thespeaker.à When both screws have been attached, tighten both of thescrews so that the stand is firmly in place.Be sure to check that the stand is firmly attached.Ä Attach the pads to the bottom of the end portion of thestand.Å Attach the other stands in the same manner and confirmthat all 4 stands have been firmly attached.Æ Place the speaker in the desired location.NoteIf force is applied to the side of the speaker, it may fall anddamage the speaker or cause personal injury. Please becareful.Spike x 4Pad x 4Washer x 4Wood screw(4 mm) x 4Screw (6 mm) x 4Stand x 4