Yamaha RX-V365 Owner's Manual

Also see for RX-V365: Service manual Owner's manual Connection guide Owner's manual Owner's manual

32 EnSet menuUse the remote control to access and adjust eachparameter.y• You can change the set menu parameters while this unit is reproducingsound.1 Press kMENU on the remote control.“AUTO SETUP” appears on the front panel display.2 Press ok / n to select “MANUAL SETUP.”3 Press oENTER to enter “MANUAL SETUP.”“1 SOUND MENU” appears on the front paneldisplay.4 Press ok / n repeatedly and then pressoENTER to select and enter the desiredmenu.The following menus appear on the front paneldisplay as you press ok / n repeatedly.5 Press ok / n repeatedly and then pressoENTER to select and enter the desiredsubmenu.• Repeat this step to navigate to and enter the itemsyou want to adjust.• To return to the previous menu level, pressqRETURN.6 Press ok / n to select the desired parameterand then ol / h to change the parametervalue.• Press oh to increase the value.• Press ol to decrease the value.7 Press kMENU to exit from set menu.Use this menu to manually adjust any speaker settings orcompensate for video signal processing delays when usingLCD monitors or projectors.y• Initial settings are indicated by (*) in this following each parameter.Use this feature to manually adjust any speaker settings.■ FRONT B speaker setting FRONT BUse this feature to select the location of the front speakersconnected to the FRONT B terminals.Notes• If you connect headphones to the PHONES jack on this unit, the sound isoutput from both headphones and the FRONT B terminals while“FRONT B” is set to “ZONE B.”• If a DSP program is selected when “FRONT B” is set to “ZONE B,” thisunit automatically enters the Virtual CINEMA DSP mode (see page 26).■ Front speakers, Center speaker, Surroundleft/right speakersFRONT, CENTER, SUR. LRSelect “LARGE (LRG)” or “SMALL (SML)” dependingon the size of your each speaker. When Center speaker orSurround speakers is not connected, select “NONE.”Initial setting:FRONT: “LARGE”CENTER: “SML”SUR. LR: “SML”Notes• When “BASS OUT” is set to “FRONT” on this page, you can select only“LARGE” in “FRONT.” If “FRONT” is set to a setting other than“LARGE” in advance, this unit automatically changes the value to“LARGE.”• When you select “NONE” in “CENTER,” the center channel signals aredirected to the front left and right speakers.• When you select “NONE” in “SUR. LR,” this unit is automatically entersthe Virtual CINEMA DSP mode (see page 26).■ LFE/Bass out BASS OUTUse this feature to select the speakers that output the LFE(low-frequency effect) and the low-frequency signals.y• If you are not satisfied with the bass sounds from your speakers, you canchange these settings according to your preference.Using set menuMANUAL SETUP.1 SOUND MENU1 SOUND MENU2 INPUT MENU3 OPTION MENU1 SOUND MENUSpeaker settings A)SPEAKER SETChoice ConditionFRONT* When FRONT B speakers are set in the main zone.ZONE B When FRONT B speakers are set in another zone. Thissetting mutes all the speakers in the main room whenFRONT B is selected by CSPEAKERS.Woofer diameter of a speaker is 16 cm (6.5 in) orlarger: LARGE (LRG)Woofer diameter of a speaker is smaller than 16 cm(6.5 in): SMALL (SML)