15 EnConnectionsEnglishINTRODUCTIONADDITIONALINFORMATION APPENDIXPREPARATIONBASICOPERATIONADVANCEDOPERATIONBoth FM and AM indoor antennas are supplied with thisunit. In general, these antennas should provide sufficientsignal strength. Connect each antenna correctly to thedesignated terminals.Notes• The AM loop antenna should be placed away from this unit.• A properly installed outdoor antenna provides clearer reception than anindoor one. If you experience poor reception quality, install an outdoorantenna. Consult the nearest authorized Yamaha dealer or service centerabout outdoor antennas.• The AM loop antenna should always be connected, even if an outdoorAM antenna is connected to this unit.Connecting the wire of the AM loop antennaAssembling the supplied AM loop antennaNote• The types of the supplied AM loop antenna is different depending on themodels.Once all connections are complete, plug the power cableinto the AC wall outlet.Press ASTANDBY/ON (or cPOWER) to turn onthis unit.y• When you turn on this unit, there will be a 4 to 5-second delay before thisunit can reproduce sound.Press ASTANDBY/ON (or bSTANDBY) to turnoff this unit.Note• In the standby mode, this unit consumes a small amount of power inorder to receive infrared signals from the remote control.Connecting the FM and AM antennasDEOANTENNAR SURROAUDIO OUTPDVR CDSN OUTDVRAMGNDFMUNBAL.75N OUT MONITOROUTMD/CD-ROUT(REC)IN(PLAY)Outdoor AM antennaUse a 5 to 10 m (16 to 32 ft)of vinyl-covered wireextended outdoors from awindow.AM loopantenna(supplied)Indoor FMantenna(supplied)GroundFor maximum safety and minimuminterference, connect the antenna GNDterminal to a good earth ground. A good earthground is a metal stake driven into moist earth.Open theleverInsert Close theleverConnecting the power cableTurning on and off the powerTurning on this unitSet this unit to the standby modeLPower cableTo the AC wall outlet
