PERIODIC MAINTENANCE AND MINOR REPAIR6-346EAU24281Replacing a turn signal lightbulb or the tail/brake light bulb1. Remove the lens by removing thescrews.XVS11WXVS11AWW/XVS11ATW2. Remove the defective bulb bypushing it in and turning it counter-clockwise.3. Insert a new bulb into the socket,push it in, and then turn it clock-wise until it stops.4. Install the lens by installing thescrews.CAUTION:ECA10680Do not overtighten the screws, oth-erwise the lens may break.EAU24350Supporting the motorcycleSince this model is not equipped with acenterstand, follow these precautionswhen removing the front and rearwheel or performing other maintenancerequiring the motorcycle to stand up-right. Check that the motorcycle is in astable and level position before startingany maintenance. A strong woodenbox can be placed under the engine foradded stability.To service the front wheel1. Stabilize the rear of the motorcycleby using a motorcycle stand or, ifan additional motorcycle stand isnot available, by placing a jack un-der the frame in front of the rearwheel.2. Raise the front wheel off theground by using a motorcyclestand.To service the rear wheelRaise the rear wheel off the ground byusing a motorcycle stand or, if a motor-cycle stand is not available, by placing1. Screw1. Screw1. ScrewU3B811E0.book Page 34 Friday, March 10, 2006 3:27 PM
