INSTRUMENT AND CONTROL FUNCTIONS3-43EAU04218Turn signal switch “ / ”To signal a right-hand turn, push thisswitch to “ ”. To signal a left-handturn, push this switch to “ ”. Whenreleased, the switch returns to the cen-ter position.Since this model is equipped with aself-canceling system, the turn signallights will self-cancel after the motor-cycle has traveled both about 150 m(490 ft) and for approximately 15 sec-onds. However, the turn signal lightscan also be canceled manually bypushing the switch in after it has re-turned to the center position.NOTE:_The self-canceling system only oper-ates when the motorcycle is moving, sothat the turn signal lights will not self-cancel while you are stopped at an in-tersection._EAU03890Engine stop switch “ / ”Set this switch to “ ” before startingthe engine. Set this switch to “ ” tostop the engine in case of an emergen-cy, such as when the motorcycle over-turns or when the throttle cable isstuck.EAU00143Start switch “ ”Push this switch to crank the enginewith the starter. EC000005CAUTION:_See page 5-1 for starting instruc-tions prior to starting the engine._EAU00152Clutch leverThe clutch lever is located at the lefthandlebar grip. To disengage theclutch, pull the lever toward the handle-bar grip. To engage the clutch, releasethe lever. The lever should be pulledrapidly and released slowly for smoothclutch operation.The clutch lever is equipped with aclutch switch, which is part of the ignitioncircuit cut-off system. (See page 3-19for an explanation of the ignition circuitcut-off system.)1. Engine stop switch “ / ”2. Start switch “ ”1. Clutch lever
