Yamaha VXL1B-24 Installation Manual

Contents

6 VXL1B-24/VXL1W-24/VXL1B-16/VXL1W-16/VXL1B-8/VXL1W-8 Installation GuideInstalling the speakersPre-installation (cable preparation)Strip the cable insulation as shown in the figure and connect the cables.NOTEDo not use solder to plate stranded wires, as this may cause the wires tobreak.You can use the included mounting bracket to install the speaker on awall. Before installation, make sure the installation area can support theweight of the speaker. Do not install on plasterboard.NOTICEWhen installing speakers, make sure the power amplifier is turned off.CAUTIONDo not install the speakers horizontally, as the speakers may fall.1 Attaching the bracket base to the wall1-1 Place the included template on the wall, to decide where theholes should go for the screws and cables.1-2 Make holes in the wall for the cables, and pull the cables fromthe amplifier out through the holes.1-3 Install the bracket base onto the wall. Position the narrow part ofthe bracket base down (towards the floor).The bracket base holes should be 5.3 mm in size.Compatible cable (Max): AWG12 (3.5 sq)7–8 mmBracket base (screwsnot included)VXL1-24: 635 mmVXL1-16: 315 mm