Yamaha YAS-101 Owner's Manual

Also see for YAS-101: Owner's manual Owner's manual

Contents

Additional Information9 EnEnglishTV remote control operation may be difficult if the unithides the sensor of your TV when beneath or under theTV. Try the two solutions below and see whether thissolves the problem.1 Move the unit in all directions.2 Remove the stands to lower the height ofthe unit.Keep the stands and screws in a safe place for future use.If you cannot solve the problem by the suggestions above,follow the procedure below and use the TV remotecontrol signal transmission function, which transmits theTV remote control signal received at the front of the unitto the remote control sensor of your TV through the IRflasher at the rear of the unit.1 Set the unit to standby mode.2 Press both the VOLUME + button andbutton of the main unit, release thebutton first, then release the VOLUME +button.The unit is turned on when switching the TV remotecontrol signal transmission function on/off.The CLEAR VOICE indicator lights up as thefollowing illustration. Check if the setting is correct.(☞ P. 11)• The default setting is off.• You can verify the current setting by turning theunit on again from standby mode.• Move the unit in all directions again if TV remote controlremains difficult.• The TV remote control signal transmission function isenabled even if the unit is in standby mode.You can use the TV remote control solely to operate byhaving the unit learn the TV remote control operations.You can operate the following functions by TV remotecontrol.• Volume down• Volume up• Power on/standby modeySome TV remote controls may not control these functions.Use the remote control supplied with the unit in this case.1 Set the unit and TV to standby mode.2 Press both the INPUT button andbutton of the main unit, release thebutton first, then release the INPUTbutton.The unit enters the remote controllearning mode.Operation by the TV remote control isdifficult (with unit beneath/under TV)NoteUsing TV remote control signaltransmission functionUse a + driver toremove the screws.The unit will be19 mm lower withoutthe stands.The remotecontrol sensor ofyour TVIR flasherOn OffThe CLEARVOICE indicator(for 2 secondsafter the unit isturned on)NotesOperate the unit by TV remote control(TV remote control learning function)No light GreenFlashes inredContinued to the next page. \