8 - 30– +ELECELECTRICAL CONTROL SYSTEMELECTRICAL CONTROL SYSTEMThe YZF-R7 features an electrical control system with the following modes:• user mode• diagnosis mode• CO emission adjustment modeNOTE:The vehicle is normally in user mode. Special tools are needed to switch to a diagnosis modeor to the CO emission adjustment mode.USER MODE• If a circuit is defective, setting the main switch to “ON” (without starting the engine) willcause the corresponding condition code to be displayed by the tachometer, the warninglight to light up, and the engine trouble symbol to blink. When the engine is started, thecondition code is no longer displayed and the engine speed appears.• Normally, when the main switch is set to “ON”, the warning light comes on for 1.4 secondsand then goes off. The warning light also comes on while the start switch is pushed.• When the engine is not running, the warning light flashes once every 0.16 second if the startswitch is pushed under the following conditions.• The fall detection switch switches off the main relay.• Ignition is cut off by the sidestand switch.• The injector operating voltage decreases to 3 V or less, or the main relay malfunctions.• The pickup coil is defective.• The fall detection switch is defective.Ofrecido por www.electromanuales.com
