E4-164) Reinstall the filter element. Make surethe O-ring is in position in the cup.Insert the cup and O-ring into the fil-ter housing 6. Screw the ring nutonto the filter housing until the ring islightly seated.5) Tighten the ring nut approximately anadditional 1/4 turn until ring nut istight. Align one of the four larger ringnut tabs into the slot of the lockingtab. Install the locking tab bolt andtighten.6) Run the engine and check the filterand lines for leaks.EMU00991ADJUSTING IDLING SPEEDw8 Do not touch or remove electrical partswhen starting or during operation.8 Keep hands, hair and clothes awayfrom flywheel and other rotating partswhile engine is running.cCThis procedure must be performed whilethe outboard motor is in the water. Aflushing attachment or test tank can beused.
