PRODUCT OVERVIEW28 JH Series Operation ManualSetup screen access and control(Setting the temperature and pressure units and engine speed pulse)Setting the temperature and pressure unitsSetting the engine speed pulse valueUse the buttons on the bottom of the LCDdisplay to set the instrument panel.Press the left button to switch between displays.043719-00E00Press and hold both buttons until"SET UP" appears.Press the left button to set the units forthe temperature and pressure display.Next, press the right button to selectMetric units (°C, BAR). The display says"METRIC".The display says "UNIT".Confirm that the display says "P10.29".If not, press the left button and change theset value.Confirm that the display says"ENGINE". Press the right button and"P10.29" appears..After confirming the display, press theright button to re-start the panel and returnto the hourmeter display.Note: This engine is pre-set to a speedpulse of P10.29.Press the left button to switch to Imperialunits (°F, PSI). The display says "ENGL".Press the right button to select and goback to the "UNIT" screen.After confirming the above, press the rightbutton to return to the "ENGINE" screen.Press the left button again to go from the"ENGINE" screen to the "EXIT" screen.1 21442 3152 312123Press the left button and go to the nextscreen "ENGINE".Confirm that the display says "ENGINE".Pressing the right button shows the screenfor the engine speed pulse setting.434125Engine type selectSelect ScrollImperial MetricSelectSelectExit setupSelect ScrollP 10.29Return to previouspage LCD controlScroll
