Yazoo/Kees ZMKH52252 Operator's Manual

Yazoo/Kees ZMKH52252 Operator's Manual Manual pdf 21 page image

English-21SETUP AND ADJUSTMENTSMotion Control Linkage AdjustmentAdjustment must be made with the rear wheelsrotating. Raise the rear of the machine and block itup so the wheels are free to rotate.Tilt seat forward and remove the seat rod so1.the seat rotates forward onto the frame.Place a 2x4 board between the foot plate2.and the center of the seat to engage the seatsafety switch.Loosen the nuts directly behind each ball3.joint on both rods that connect the pump armto the motion control assemblies.Start the engine. The park brake must be4.engaged and the motion control levers inthe neutral slots to start the engine. Run theengine approximately half throttle.Release park brake to allow the wheels to5.rotate.Begin with either side and put the motion6.control lever into the neutral position.Adjust the motion control linkage by rotating7.the double nuts in the proper direction untilthe wheel stops rotating.Move the motion control lever forward and8.into the neutral position and into the neutralslot. The wheel must be stopped completelyat this point.Do the same in reverse and release the9.lever. The lever should return to neutral onits own.Run engine full throttle to make sure wheels10.do not rotate. Readjust if any rotation occurs.Repeat the whole process for the opposite11.side and tighten the nuts against the balljoints.Turn machine off.12.Reinstall the seat rod and check the wiring13.harness to the seat safety switch for a goodconnection and return the seat to the normalposition.park Brake AdjustmentSee your authorized Yazoo/Kees dealer for any parkbrake adjustment.Turn HereTo AdjustLoosen HereLoosen Here(Left Hand Thread)Motion ControlLeverPump ArmCAUTION!Keep hands, feet and clothing away fromrotating tires.