saFeTy17WARNING!This mower is equipped with aninternal combustion engine andshould not be used on or near anyunimproved forested, bush coveredor grassy lands unless the engine'ssystem is equipped with a sparkarrester meeting applicable local orstate laws (if any).Rollover Protection System (ROPS)The RoPS increases the basic weight of the unit by 73lbs/33 kg.Do not use RoPS as a lifting, attaching or•anchoring point.Do not use RoPS for wrecking or towing.•Do not exceed Max GVW: 2822 lbs/1283 kg.•Read machine’s operator manual before each•use.Securely fasten the seat belt if the unit has a•RoPS.Where possible, avoid operating the unit near•ditches, embankments and holes.Reduce speed when turning, crossing slopes and•on rough, slick or muddy surfaces.Stay off slopes too steep for safe operation.•Watch where you are going, especially at row•ends, on roads and around trees.Do not permit others to ride.•operate the mower smoothly - no jerky turns,•starts or stops.When mower is stopped, set brakes securely and•use park brake.If any part of RoPS is damaged, the entire RoPS•must be replaced.Check all bolts including seat belt for correct•torque before each use.Check RoPS structure for damage before each•use.RoPS bar is NoT intended for use in sub zero•temperatures.WARNING!The rollover protection system'scapabilities may be impaired bydamage if the mower is overturnedor if alteration to the ROPS occurs. Ifthese conditions take place, the totalstructure MUST be replaced.Spark ArrestorsA spark arrester is standard equipment on the unitand is attached to the engine muffler. Clean theinterior screen regularly, depending on usage andconditions.To clean, remove the clamp securing the tail pipe.Remove the tail pipe and slide the spark arrestorscreen out of the muffler. Clean carbon from thescreen with a soft brush or cloth.Replace screen and reattach the tail pipe, orientingthe trail pipe either horizontally or upwards, away fromgrassy surfaces.WARNING!The engine and the exhaust systembecome very hot during operation.There is risk for burns if touched.Allow engine and exhaust system tocool at least two (2) minutes beforerefueling.8011-514Regularly clean spark arrestor screen