Yealink SIP-T23G User Manual
Also see for SIP-T23G: ManualAuto provisioning guideGetting startedRecovery guideAdministrator's guide
                                                                                                                                                      | |
Contents
| 
Getting Started13To connect the PoE for the SIP-T23P/T23G IP phone:1. Connect the Ethernet cable between the Internet port on the phone and anavailable port on the in-line power switch/hub.NoteAfter your phone is powered on, the system boots up and performs the following steps:Automatic Phone InitializationThe phone finishes the initialization by loading the saved configuration. The LCD screendisplays “Welcome Initializing…please wait” during this process.DHCP (Dynamic Host Configuration Protocol)The phone attempts to contact a DHCP server in your network to obtain valid IPv4network settings (e.g., IP address, subnet mask, default gateway address and DNSaddress) by default.NoteYou can view phone status via phone user interface or web user interface.Available information of phone status includes: Network status (e.g., IPv4 Status, IPv6 Status, IP Mode and MAC address).If in-line power is provided, you don’t need to connect the phone to the power adapter.Make sure the switch/hub is PoE-compliant.The phone can also share the network with another network device such as a PC(personal computer). This is an optional connection.Important! Do not remove power from the phone while it is updating firmware andconfigurations.If your network does not use DHCP, proceed to Basic Network Settings on page 15. |
Related manuals for Yealink SIP-T23G
manualsdatabase
Your AI-powered manual search engine