Advanced Features443Default BlankWeb UI Features->Pick up & Park->Park Retrieve CodeParameter features.call_park.direct_send.enable .cfgDescriptionIt enables or disables the IP phone to dial out the call park code/park retrieve codedirectly when pressing the Park/Retrieve soft key. It is only applicable to FAC call parkmode.Note: It works only if “features.call_park.park_mode” is set to 1 (FAC) and you haveconfigured the call park code/park retrieve code.PermittedValues0-Disabled, the IP phone will enter the pre-dialing screen when pressing thePark/Retrieve soft key. The user can dial the specific extension manually or press theBLF/BLF List or Speed Dial key to park the call to the specific extension or retrieve thecall parked from the specific extension.1-EnabledDefault 1Parameter features.call_park.line_restriction.enable .cfgDescriptionIt enables or disables the IP phone to park a call using the line specified by theparameter “linekey.X.line/expansion_module.X.key.Y.line”. It is only applicable tothe scenario that the user uses the Park key to park a call.Note: It works only if “features.call_park.park_mode” is set to 2 (Transfer). It is notapplicable to T19(P) E2 IP phones.PermittedValues0-Disabled, call is parked or retrieved by the current line. The current line is in callstate.1-Enabled, call is parked or retrieved by the specific line.Default 0Example: Setting Call Park and Retrieve in FAC ModeThe following example shows configuration for FAC call park mode.Examplefeatures.call_park.park_mode = 1features.call_park.enable = 1features.call_park.park_code = *68features.call_park.park_retrieve_code = *88After provisioning, the call park mode is set to FAC. A Park soft key will display on the phone during anactive call, and a Retrieve soft key will display on the Dialing screen. You can press the Park soft key topark a call, or press the Retrieve soft key to retrieve a parked call.
