York TCHD18 Technical Manual

Also see for TCHD18 THRU 60: Technical guide

Contents

York TCHD18 Technical Manual Manual pdf 4 page image

556454-YTG-B-04104 Johnson Controls Unitary ProductsPROCEDURES:1. Unit factory charge listed on the unit nameplate includes refrigerant for the condenser, the smallest evaporator and 15 feet of interconnectingline tubing.2. Verify the TXV and additional charge required for specific evaporator coil in the system using the above table.3. Additional charge for the amount of interconnecting line tubing greater than 15 feet at the rate specified in Physical and Electrical Data Table.4. For TXV matches requiring additional charge, the refrigerant needs to be weighed in for specific coil match and lineset length.5. Permanently mark the unit nameplate with the total system charge. Total System Charge = Base Charge (as shipped) + adder for evaporator +adder for line set.UC18 1 – – – – –UC24 5 5 – – – –UC30 5 5 3 – – –UC36 7 7 4 1 – –UC42 – 9 3 0 – –UC48 – 25 21 17 6 –UC60 – – – – 11 –FOOTNOTES:1. For applications requiring a TXV use 1TVM series kit.2. Systems matched with furnace or air handlers not equipped with blower-off delays may require blower Time Delay Kit 2FD06700224.3. PC coils cannot be used in downflow or horizontal applications. FC coils cannot be used in horizontal applications.System Charge for Various Matched Systems (Continued)Outdoor Unit TCHD18S41S3 TCHD24S41S3 TCHD30S41S3 TCHD36S41S3 TCHD48S41S3 TCHD60S41S3Required Orifice or TXV 1 1TVM4F1 1TVM4F1 1TVM4G1 1TVM4G1 1TVM4J1 1TVM4K1Factory Charge, lbs-oz 2 - 14 3 - 5 4 - 0 4 - 8 5 - 5 5 - 6Indoor Coil 2,3 Additional Charge, oz