ZENEC ZE-NA2000 - NAVIGATION Software Manual

Also see for ZE-NA2000 -: Brochure Brochure Broschüre

Contents

ZENEC ZE-NA2000 - NAVIGATION Software Manual Manual pdf 17 page image

172.2.4 Using the Cursor (the selected map location)First, place the Cursor at the desired map location with one of the following options:x Use the Find menu to select a location. The map returns with the selected point (the Cursor) inthe middle, and the Cursor menu appears with the available options.x Tap the screen and tap again to place the Cursor at the desired location. Now tap toopen the Cursor menu.You can perform the following actions:Button ActionIn the active route, uses the Cursor as the start point by replacing the currentGPS positionIn the active route, uses the Cursor as the destination by replacing the previousdestinationIn the active route, uses the Cursor as a via point (an intermediate destination)preceding the destinationIn the active route, uses the Cursor as the destination while keeping theprevious destination as a via pointShows the different routes calculated by the available routing methods. Choosethe one that suits your needs the bestSaves the Cursor as a POISaves the Cursor as a Favourite locationMarks the map with a Pin at the CursorOpens a screen with the name, address and coordinate information of theCursor, and the list of POIs near it2.3 ZENEC Navigation Software concepts2.3.1 Smart ZoomSmart Zoom provides much more than just a usual automatic zoom feature:x While following a route calculated by ZENEC Navigation Software: when approaching aturn, it will zoom in and raise the view angle to let you easily recognise your manoeuvre at thenext junction. If the next turn is at a distance, it will zoom out and lower the view angle to be flatso you can see the road in front of you.x While driving without an active route in ZENEC Navigation Software: Smart Zoom willzoom in if you drive slowly and zoom out when you drive at high speed.