ZENEC ZE-NA2000 - NAVIGATION Software Manual

Also see for ZE-NA2000 -: Brochure Brochure Broschüre

Contents

ZENEC ZE-NA2000 - NAVIGATION Software Manual Manual pdf 27 page image

274. Enter the street name:1. Tap .2. Start entering the street name on the keyboard.3. Get to the list of results:x After entering a couple of characters, the names that match the string appear in alist.x Tap to open the list of results before it appears automatically.4. Select the street from the list.5. Enter the house number:1. Tap .2. Enter the house number on the keyboard.3. Tap to finish entering the address.6. A list appears with the matching addresses. Tap the desired one.7. The map appears with the selected point in the middle. Tap from theCursor menu. The route is then automatically calculated, and you can start navigating.3.1.2.3 Entering an address without knowing the district/suburbLong roads can run across several districts or suburbs. You may not know what particular housenumber is located where. In this case, follow the instructions below:The procedure is explained starting from the Navigation menu.1. Tap the following buttons: , .2. By default, ZENEC Navigation Software proposes the country/state and settlement where youare. If needed, tap the button with the name of the country/state, and select a different onefrom the list.3. If needed, change the settlement:x To select the settlement from the list of recently used ones, tap the button.x To enter a new settlement:1. Tap the button with the name of the settlement, or if you have changed thecountry/state, tap .2. Start entering the settlement name on the keyboard.3. Get to the list of search results:x After entering a couple of characters, the names that match the stringappear in a list.