ZENEC ZE-NA2000 - NAVIGATION Software Manual

Also see for ZE-NA2000 -: Brochure Brochure Broschüre

Contents

ZENEC ZE-NA2000 - NAVIGATION Software Manual Manual pdf 61 page image

6161Button DescriptionBackground You can choose the image to be used as the menu backgroundimage.4.5.6 TMC settingsYou can set up the connection to the TMC receiver. If the TMC receiver is working, you can select theradio station to be received. Tap the following buttons: , , .If there is no TMC receiver connected to ZENEC Navigation Software, you have the following options:Button DescriptionNo TMC Hardware Found! The first line of the screen informs you about the connection status ofthe GPS receiver.Connecting the TMC receiver is automatic in ZENEC NavigationSoftware, so normally you will not need this screen of settings at all.Protocol The communication protocol used between the TMC receiver and theapplication.Port The communication port used between the TMC receiver and theapplication.Baud Rate The communication speed used between the TMC receiver and theapplication.Autodetect Tap this button and let ZENEC Navigation Software find and connectto the TMC receiver.With a TMC receiver already connected, the content of the screen is different:Button DescriptionUse Auto-tuner If Auto-tuner is enabled, the tuner of ZENEC Navigation Softwaresweeps through the FM CCIR radio band searching for a TMC signal.The first station with TMC data will be used automatically. When noTMC signal is available, the tuner keeps on searching. Turn off Auto-tuner to select a radio station manually.,When Auto-tuner is turned off, search for the desired radio stationmanually with these buttons.Exclude This Station Push this button to put the currently received FM radio station on anexception list, and make ZENEC Navigation Software search foranother station instead.Show Excluded Stations This button opens the list of radio stations previously excluded. Youcan re-enable any or all of the excluded stations.