Zanussi DVI 42 Instructions For The Use And Care

Also see for DVi 42: Instructions for the use and care Use and care instruction

InstallationIntroductionIf this new freezer, equipped with the mag¬netic closure of the door replaces an older. type with a spring-closed door, we adviseyou to make sure that the door of thediscarded freezer may no longer be closedfrom the outside.In this way, children who come to play nearthe discarded freezer will be unable to closethemselves within, at the risk of their lives.LocationWe advise you to position your freezer farfrom all sources of heat (oven, kitchen units,or excessive sunlight). For the satisfactoryoperation of the freezer, the room tempera¬ture must remain within the range of from+16 and +32° C.For building the freezer into a recessedinstallation area, or changing the openingdirection of the door (when required), seethe respective paragraph.Electrical ConnectionThis appliance operates on a 220/240 V,50 Hz power supply. Make sure that yourown electrical supply voltage is within therange marked on the rating plate locatedinside the cabinetEarthingWARNING: THIS APPLIANCE MUST BEEARTHED.The manufacturer declines all liability whennever this safety measure is not observed.If the plug that is fitted to your appliancedoes not suit the wall socket it must be cutoff and fitted with an appropriate plug. Thecut-off plugshould be immediately disposedof to prevent the hazard of electric shocksin the event that it is plugged into a 13 Ampsocket in another part of your home.IMPORTANT:The wires in this mains lead are colouredin accordance with the following code:GREEN/YELLOW: EARTHBLUE : NEUTRALBROWN: LIVEIf you fit your own plug, the colours of thewires in the mains lead of your appliancemay not correspond to the markings indic¬ating the terminals in your plug. If this isthe case, proceed as follows:Connect the green/yellow (earth) wire tothe terminal in the plug which is markedwith the letter «E», or the earth symbol ,or coloured green, or green and yellow.Connect the blue (neutral) wire to the ter¬minal in the plug which is marked with theletter «N», or coloured black.Connect the brown (live) wire to the termi¬nal which is marked with the letter «L», orcoloured red.The plug moulded onto the cord (incorpo¬rates a fuse. For replacement, use a 13 AmpBS 1362 fuse. Only ASTA-approved fusesshould be used. The fuse cover/carriermust be replaced when changing the fuse.The correct fuse cover/carrier is the oneshown by the coloured insert at the base of4