Zanussi Z 8050 WOS Instructions For Use And Installation Instructions

Contents

35FEEDER CABLE SECTION TYPEHO5RR-F230 V 3 x 0,75 mm2230 VPENL1(L2)Fig. 9.2ELECTRICAL FEEDER CABLECONNECTIONTo connect the supply cable:- Remove the screws securing thecover “A” on the rear of the cooker(fig. 9.1).- Feed the supply cable through thecable clamp “D”. The supply cablemust be of a suitable size for the cur-rent requirements of the appliance;see the section “Feeder cable section”(fig. 9.1).- Connect the wires to the terminalblock “B” as shown in the diagram infigure 9.2; or connect the phase wiresto the terminal block “B” and the earthwire to the terminal PE (fig. 9.1) asshown in figure 9.2.- Take up any slack in the cable andsecure with the cable clamp “D”.- Replace the cover “A”.Fig. 9.1DBPEASwitches igniter and electrodes can bereplaced after lifting the cooktop, follow-ing the instructions shown in the chapter“REPLACEMENT OF THE TOP INJEC-TORS”.REMPLACEMENT OF ELECTRICALCOMPONENTS SITUATED UNDERTHE COOKTOPBefore effecting any intervention onthe electrical parts of the appliance,the connection to the network mustbe interrupted.

/ 36

Related manuals for Zanussi Z 8050 WOS