12341 Burner cap2 Burner crown3 Thermocouple4 Ignition candleWarning! Do not keep control knob pressed formore than 15 seconds.If the burner does not light after 15 seconds, release thecontrol knob, turn it into off position and wait for at least 1minute before trying to light the burner again.Turning the burner offTo put the flame out, turn the knob to the symbol .Warning! Always turn the flame down or switch it offbefore you remove the pans of the burner.Lid Safety DeviceLid has safety device, which cut off gas supply for hob. Itworks only when lid is closed.Warning! Always use the control knob to switch offa burner. Do not use the lid as a cut-off device.Hob - Helpful hints and tipsEnergy savings• If possible, always put the lids on the pans.• When the liquid starts to boil, turn down the flame tobarely simmer the liquid.Use pots and pans with bottom applicable to the di-mension of burner.Burner Diameters of cookwareRapid 180 mm - 260 mmBurner Diameters of cookwareSemi-rapid 120 mm - 220 mmAuxiliary 80 mm - 160 mmUse cookware with the bottom as thick and flat as possi-ble.Hob - Care and CleaningWarning! Refer to "Safety information" chapter.Warning! Switch the appliance off and let it cooldown before you clean it.Warning! For safety reasons, do not clean theappliance with steam cleaners or high-pressurecleaners.Warning! Do not use abrasive cleaners, steel woolpads or acids, they can cause damage to theappliance.• To clean the enamelled parts, cap and crown, wash itwith warm soapy water.• Stainless steel parts wash with water, and then dry witha soft cloth.• The pan supports are not dishwasher proof; they mustbe washed by hand .• Make sure you position the pan supports correctly aftercleaning.• To make burners work correctly, make sure that thearms of the pan supports are in the centre of the burn-er.• Be very careful when you replace the pan supports toprevent the hob top from damage.After cleaning, dry the appliance with a soft cloth.7