Zanussi ZCM 700 X Instruction Booklet

Zanussi ZCM 700 X Instruction Booklet Manual pdf 27 page image

27A) End of shaft with nutB) WasherC) ElbowInstallationIMPORTANTThis cooker must be installed by qualifiedpersonnel to the relevant British Standards.Any gas installation must be carried out bya registered CORGI installer.The manufacturer will not accept liability,should the above instructions or any of theother safety instructions incorporated inthis book be ignored.Connecting to GasThis cooker is designed to be installed with anappliance flexible connection. Connection is made tothe RC 1/2 (1/2" B.S.P.) threaded entry pipe locatedjust below the hotplate level on the rear right-handside of the cooker.A second entry pipe is located on the rear left-handside and it is locked by a security nut. Should thissecond entry pipe allow a safer gas connection,remove the security nut and the relevant gasket fromthe left-hand entry pipe and place it onto the mainentry pipe, ensuring the gasket is correctly positionedand the nut is well secured.When the final connection has been made, itis essential that a thorough leak test iscarried out on the cooker and installation.Ensure that the main connection pipe doesnot exert any strain on the cooker.Note:For certain types of gas bayonet connection used, itmay not be possible for the appliance to be pushedfully back to the wall stops.Important:Flexible tubing MUST comply with BS.669 CurrentEdition.FO 0264