Zanussi ZDI 200 User Manual
                                | |
Contents
| 
WARNING!The electrical cable for the safety valve is in thedouble-walled water inlet hose and is live.Therefore do not immerse the water inlet hoseor the safety valve in water.Take care when installing the water inlet hose. Place the water inlet hose in such a way thatit is always lower than the bottom edge of thesafety valve.If the water inlet hose or the safety valve isdamaged, remove the mains plug immediately.CAUTION!A water inlet hose with safety valve MUST onlybe replaced by your local Service Force Centre.Drain hoseConnect drain hose tothe sink. Secure it withthe supplied hose clamp.Required height: 30 to100 cm above bottom ofthe dishwasher.Ensure that the hosesare not kinked, crushedor entangled.When connecting thedrain hose to an undersink trap spigot, the en-tire plastic membrane(A) must be removed.Failure to remove all themembrane will result infood particles building upover time eventuallyblocking the dishwasherdrain hose spigot.If you use a drain hose extension the totallength should not be longer than 4 metres.Likewise the internal diameter of the couplingsused for connections to the waste outlet mustbe no smaller than the diameter of the hoseprovided.24 |
Related manuals for Zanussi ZDI 200
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine