correctly, you will help prevent potential nega-tive consequences for the environment andhuman health, which could otherwise becaused by inappropriate waste handling of thisproduct. For more detailed information aboutrecycling of this product, please contact yourlocal council, your household waste disposalservice or the shop where you purchased theproduct.What to do if…The dishwasher will not start or stops duringoperation.Certain problems are due to the lack of simplemaintenance or oversights, which can besolved with the help of the indications describedin the chart, without calling out an engineer.Switch off the dishwasher and carry out the fol-lowing suggested corrective actions.Fault code and malfunction Possible cause and solution• continuous flashing of the start/cancel indicatorlight• 1 intermittent audible signal• 1 flash of the "end of programme" indicator lightThe dishwasher does not fill with water.• The water tap is blocked or furred with limescale.Clean the water tap.• The water tap is turned off.Turn the water tap on.• The filter (where present) in the threaded hose fittingat the water inlet valve is blocked.Clean the filter in the threaded hose fitting.• The water inlet hose has not been correctly laid orit is bent or squashed.Check the water inlet hose connection.• continuous flashing of the start/cancel indicatorlight• 2 intermittent audible signals• 2 flashes of the "end of programme" indicatorlightThe dishwasher will not drain.• The sink spigot is blocked.Clean out the sink spigot.• The water drain hose has not been correctly laid orit is bent or squashed.Check the water drain hose connection.• continuous flashing of the start/cancel indicatorlight• 3 intermittent audible signals• 3 flashes of the "end of programme" indicatorlight• Anti-flood device is activated.Close the water tap and contact your local ServiceForce Centre.19