Zanussi ZGL642T User Manual

Contents

ABCDA) Burner capB) Burner crownC) Ignition candleD) ThermocoupleWarning! Do not keep the control knobpushed for more than 15 seconds.If the burner does not light after 15 seconds,release the control knob, turn it into off positionand try to light the burner again after minimum1 minute.Important! In the absence of electricity youcan ignite the burner without electrical device;in this case approach the burner with a flame,push the relevant knob down and turn itcounter-clockwise to maximum gas releaseposition.If the burner accidentally goes out, turn thecontrol knob to the off position and try tolight the burner again after minimum 1 minute.The spark generator can start automatical-ly when you switch on the mains, after in-stallation or a power cut. It is normal.Turning the burner offTo put the flame out, turn the knob to the sym-bol .Warning! Always turn the flame down orswitch it off before you remove the pansfrom the burner.Helpful hints and tipsWarning! Refer to the Safety chapters.Energy savings• If possible, always put the lids on the pans.• When the liquid starts to boil, turn down theflame to barely simmer the liquid.Use cookware with diameters applicable to thesize of burners.Burner Diameters of cookwareRapid 180 - 260 mmSemi-rapid 120 - 220 mmAuxiliary 80 - 160 mmWarning! Make sure that the bottoms ofpots do not stand above the controlknobs. If the control knobs are under thebottoms of pots, the flame heats them up.Do not put the same pan on two burners.Warning! Make sure that pot handles isnot above the front edge of the cooktop.Make sure that pots are centrally put on therings in order to get maximum stability and toget lower gas consumption.Do not put unstable or damaged pots on therings to prevent from spill and injury.Warning! Do not use a flame diffuser.6 www.zanussi.com