InstallationWarning! Refer to the Safety chapters.Warning! The following instructions aboutinstallation, connection and maintenancemust be carried out by qualified personnel incompliance with standards and localregulations in force.Important safety requirementsThis hob must be installed in accordance withthe Gas Safety (Installation and Use) Regula-tions (Current Edition) and the IEE Wiring Reg-ulations (Current Edition).For appliances installed in the Republic of Ire-land please refer to NSAI- Domestic Gas In-stallation I.S. 813 Current Editions and the ET-CI Rules for Electrical Installations.Provision for ventilationDetailed recommendations are contained in thefollowing British Standards Codes Of Practice:B.S. 6172/ B.S. 5440, Par. 2 and B.S. 6891Current Editions.The hob should not be installed in a bed sittingroom with a volume of less than 20 m³. If it isinstalled in a room of volume less than 5 m³ anair vent of effective area of 100 cm² is required.If it is installed in a room of volume between 5m³ and 10 m³ an air vent of effective area of 50cm² is required, while if the volume exceeds 11m³ no air vent is required.However, if the room has a door which opensdirectly to the outside no air vent is requiredeven if the volume is between 5 m³ and 11 m³.If there are other fuel burning appliances in thesame room, B.S. 5440 Part 2 Current Edition,should be consulted to determine the requisiteair vent requirements.For appliances installed in the Republic of Ire-land please refer to the NSAI- Domestic GasInstallation I.S. 813 Current Editions TableFour.LocationThe hob may be located in a kitchen, a kitchen/diner or bed sitting room (with a volume greaterthan 20 m³), but not in a bathroom or showerroom.The minimum distance combustible materialcan be fitted above the hob in line with theedges of the hob is 400 mm. If it is fitted below400 mm a space of 50 mm must be allowedfrom the edges of the hob.For appliances installed in the Republic of Ire-land please refer to NSAI- Domestic Gas In-stallation I.S 813 Current Edition Section 7-Permitted Locations of Appliance.Gas ConnectionWarning! Any gas installation must becarried out by a GAS SAFE REGISTERinstaller.Make sure that, once the hob is installed, it iseasily accessible for the engineer in the eventof a breakdown.The manufacturer will not accept liability,should the above instructions or any of the oth-er safety instructions incorporated in this in-struction booklet be ignored.On the end of the shaft, which includes the G1/2" threaded elbow, adjustment is fixed so thatthe washer is fitted between the componentsas shown in the diagram. Screw the parts to-gether without using excessive force.A B CA) End of shaft with nutB) WasherC) ElbowConnection to the gas supply should be witheither rigid or semi-rigid pipe, i.e. steel or cop-per.The connection should be suitable for connect-ing to R 1/2 (1/2 BSP male thread).9www.zanussi.com