20With regard to the protection against overheatingof surrounding furniture surfaces this appliancecorresponds to type Y. This appliance or the built--in cupboard for the appliance respectively may belocated with the rear wall and one side wall to wha-tever high walls or furniture respectively and withthe other side to another appliance or furniture ofthe same height as this appliance.Hob installationD Cut out the worktop with the cut--out size as sta-ted. The toleranced sizes must not be exceeded..Saw exactly at the marking line. Recommenda-tion: Mark the cut--out with a steel needle.Cover--glue the line in order to avoid splintering of thecoating when cutting.D Clean the worktop in the cut--out sectionD With tiled worktops the grooves within the contactarea of the cooking area must completely be filledup with groove material.D Then fasten the catch springs with screws in thecut--out at the marked position. The distortion ofthe springs serves as a stop on the worktop.D With natural, artificial stone, or ceramic plates thesprings can be glued in with special adhesive(synthetic resin, two--component adhesive, etc.)D The cooking area is entered from the top into thecut--out section, centered and firmly pressed onuntil the springs will catch.D Check the seal in the supporting frame for perfectseating and gapless support. Please do not applyfurther silicone sealing matter as this will compli-cate the removal of the hob if servicing is neces-sary.12R5sealing frameceramic glass platesnap--in clampworktop