Zanussi ZOP37902XK User Manual

Also see for ZOP37902: User manual User manual User manual User manual

Contents

Zanussi ZOP37902XK User Manual Manual pdf 17 page image

Removing the shelf supports1 Pull the front ofthe shelf supportaway from the sidewall.212 Pull the rear endof the shelf supportaway from the sidewall and remove it.Installing the shelf supportsInstall the shelf supports in the opposite se-quence.The rounded ends of the shelf supportsmust point to the front.PyrolysisWarning! The appliance becomes veryhot. There is a risk of burns.Caution! If a hob is installed with theappliance, do not use it at the same timesas the Pyrolysis function. It can cause damageto the appliance.1. Remove the removable shelf supports (ifapplicable) and accessories from the appli-ance. Refer to "Removing the shelf sup-ports".Caution! Do not let the removable shelfsupports stay in the appliance during thecleaning procedure. There is a risk of damage.2. Remove the worst dirt manually.3. Fully close the oven door.The cleaning procedure cannot start if youdo not close the oven door.4. Set the function Pyrolysis. Refer to "Ovenfunctions".5. When flashes, press + or - to set thenecessary procedure:– P1 - if the oven is not very dirty. The pro-cedure is 1 h long.– P2 - if the oven is more dirty. The proce-dure is 1 h 30 min long.6. Press to start the procedure. You canuse the End function to delay the start ofthe cleaning.When the oven is at the set temperature,the door locks. The display shows the sym-bol and the bars of the heat indicator.To stop Pyrolysis before it is completed,turn the knob for the oven functions to theoff position.When Pyrolysis is completed, the displayshows the time of day. The oven door stayslocked. When the appliance is cool again, anacoustic signal sounds and the door unlocks.During the Pyrolysis the oven lamp is off.Cleaning reminderTo remind you that Pyrolysis is necessary, PYRflashes in the display for 10 seconds after eachactivation and deactivation of the appliance.The cleaning reminder goes off thedisplay:• After the end of the Pyrolysis function• If you press + and - at the same time whilePYR flashes in the display.Oven lampWarning! Be careful when you changethe oven lamp. There is a risk of electricalshock.Before you change the oven lamp:• Deactivate the oven.• Remove the fuses in the fuse box or deacti-vate the circuit breaker.Put a cloth on the bottom of the oven toprevent damage to the oven light andglass cover.Always hold the halogen lamp with a cloth toprevent grease residue from burning on thelamp.17www.zanussi.com