ZAP Series 3 Technical ManualAuto-Close Timer ProgrammingZAP Series 3 Technical ManualAuto-Close Timer ProgrammingSeries 3 Auto-Close Timer ProgrammingZAP Series 3Simply LogicalZAP Controls100 Waterloo Blvd. Anglesey Business Park, Littleworth Road, Cannock, Staffordshire, EnglandUK Contact 011-44-154-387-9444 sales@zap-uk.comUSA Contact 931-510-4432 sales@zap-america.comUSA Tech Support 931-510-4432 via telephone or textOnline www.zap-uk.comWarning ElectricalShock HazardTo prevent serious injury or deathalways ensure power is disconnectedwhen wiring anything into the ZAPController.Note that the door will not auto close unless the401002 photo eye system is employed. See 4010002phot eye installation page.Start with the door in the fully closed position.Enable the Auto-Close timer by setting DIP switchNo. 4 to ON. (Figure A)Press and hold the program button. (Figure B)Release the button after the 2nd flash of the ACKLED or beep if the 850 beeper module is installed.(Figure C)Next press the OPEN push button.After the door has fully opened and the operatoropen LED has turned off. Begin timing on your watchthe desired close delay. Maximum is 4 Minutes.When the desired time delay is reached, press theCLOSE push button twice. The desired delay is nowstored into the memory and will be retained duringany power interruptions.The programming process pressing the button twicewill ensure the door closes regardless of obstructionfor security reasons.If you prefer that the door should reopen and stayopen following an obstruction strike, then only pressthe close button once, instead of twice, as describedabove.If you wish to change programmed delay, simplyrepeat the programming function.Figure ADIP SW 4Figure BProgramFigure CAcknowledge56
