Zenith A20A22DOM Operating Manual And Warranty

Also see for A20A22D: Service manual Operating guide Operating guide

Locate the Antenna/Cable jack onthe back of your EntertainmentMachine.Connect the cable that runs fromthe wall directly to this jack,according to the diagram to theright.Remove the back of the remoteand put in two AAA batteries.Plug in your TV. Do not plug itinto a switched outlet. YourEntertainment Machine is designedto operate on household current,120-volt 60 Hertz AC. Do notattempt to operate it on DCCurrent.Go to page 8 to Auto Program yourEntertainment Machine.206-3371-AI N S TA L L AT I O N S TA N DA R DP A G E 6Connect youroff-airantenna andVCR to yourEntertainmentMachine.Hook Up Antenna and VCR to your TVTV back panel(expanded view)AntennaCableTV backInOut AudioVideo3 4VCR backVCR back AV panelFlat wire(300 ohm)Antenna300/75 ohmAdapterRF coaxial wire(75ohm)not includedwith TVoutputswitchAudio In Video A/V cablesnot includedwith TVRemember, when screwingRF cables onto jacks, clockwisetightens, and counterclockwiseloosens.No A/V cables are included withyour Zenith EntertainmentMachine.Without A/V cables, most VCRs willnot play videocassettes in stereosound.back ofremote1235TV back panel(expanded view)AntennaCableTV back RF coaxial wire(75ohm)not includedwith TVAudio In VideoA/V cablesnot includedwith TVInOut AudioVideo3 4VCR backVCR back AV paneloutputswitchRF coaxial cable(75ohm)Antenna4Flat wire Antenna to TV with VCRCoaxial wire Antenna to TV with VCR