Zenith C27C35T Operating Manual & Warranty

Also see for C27C35: Operating guide & warranty

206-3590P A G E 3 8Programming the RemoteMini glossaryPROGRAMMING Procedure to set up remote to operate other equipment.PRG Programming mode key.DEVICE Infra-red remote controllable electronic accessory equipment.123456Set up your remote control to operate other brand name devicesPRG POWERCABLE VCR AUX TVSURFENTERFLASHBK MUTECHANNELCHANNELVOLUME VOLUME1 2 34 5 6708 9MENUREWIND FFWDRECORDQUITPIPSWAPFREEZCCTV/VCRSOURCEPAUSE TIMERPLAYSTOP746Programming your Zenith remote may allow you to use one remoteto work up to 7 different devices.Not all devices will work with your Zenith remote control.53Turn on the device you want to program.On the chart on page 42/43, find the type of device you’reprogramming, and then find the brand name. Make a note ofthe three-number code, you’ll need it soon.Press and hold PRG. It’s recessed so it doesn’t get pushedaccidentally. Use a small, blunt object. When the indicatorlight turns on, you can release PRG.Push the key name with the type of device you’re program-ming (VCR, CABLE, AUX, TV).Using the NUMBER keypad, enter the three-number code youfound on page 42/43.Press ENTER to save the code. (The indicator light will flash3 times, then turn off to indicate the code is valid.)Point the remote at the device and push POWER. It shouldturn off. If not, try the other codes listed and continue fromstep three.Note: To reset remote to factory settings, enter 9-1-1, inStep 5.Note: After programming, be sure to press the mode keyfirst to operate the device you have just programmed.7Indicator Light