Zenith H1934Y Installation And Operating Manual, Warranty

P A G E 1 1206-3490-OAuto Program (Channel Search)Use Auto Program to specify Antenna or cable serviceincoming signal source and automatically store all of thechannels that are found by channel search.With the Installer remote control in hand, press thePOWER key to turn on the Concierge TV.Press the MENU key so the Setup menu appears.Using SELECT on the remote control, highlight AutoProgram on the screen.Press a Right or Left ADJ (Adjust) arrow to reach theAuto Program screen.Using SELECT, choose either Cable TV or Off-Air Antennaon your screen.Press a Right or Left ADJ arrow to begin the ChannelSearch.Press ENTER when finished.1234567 TIMERCHPREVIEWENTER1 2 34 5 67 8 90POWERFLSHBKMUTEVOLUMECHANNELTV/FMCCMENU BANKADJ ADJSELECT3/5Mini glossaryOFF-AIR-ANTENNA If the guest can only view over-the-air broadcasts, select Antenna.CABLE If you provide cable service to your guests, select Cable.Note: Auto Program finds channels being received by the TVtuner.Cable will not work unless the lodge provides a cable service.(If the Auto Program line appears in red, then it did not passone of the internal tests. To set Auto Program to white, set theupper nibble of the EEPROM location $1FFh to $B0h.)4/6172