Zenith H1934Y Installation And Operating Manual, Warranty

P A G E 6 206-3490-OMini glossary75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wiresticking through the middle, and it screws onto the threaded jack on the back of your TV.A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screwson one end and a round opening with a wire sticking out on the other end.Hook Up Your Antenna to the TVConnect an off-air antenna to the Concierge TV.If you have a 75 ohm RF cable, then you don’t needany adapters!Remember, when screwing RF cables onto jacks, clock-wise tightens, and counterclockwise loosens.A 300 to 75 ohm adapter is not included with theZenith Concierge TV.Model H2539Y does not have the MPI card.300 TO 75 OHMADAPTERAntennaTV backTV back panel(expanded view)VIDEOINANTENNACABLEM.P.I.SuperPort SPEAKEROUTAUDIOINFlat wire(300 ohm)300/75 ohmAdapterTV backTV back panel(expanded view)VIDEOINANTENNACABLEM.P.I.RF coaxial wire(75ohm)AntennaSuperPort SPEAKEROUTAUDIOINLocate the Antenna/Cable jack on the back of yourConcierge TV.Connect the cable that runs from the wall directly tothis jack, according to the diagram to the right.Remove the back of the remote and put in two AA bat-teries.Plug in your TV. Do not plug it into a switched outlet.Your Entertainment Machine is designed to operate onstandard current, 120-volt 60 Hertz AC. Do not attemptto operate it on DC Current.Go to page 11 to Auto Program your Concierge TV.back ofremote12345