Zenith H1934Y Installation And Operating Manual, Warranty

P A G E 8 206-3490-OHook Up Antenna and VCR to the TVConnect your off-air antenna and VCR to the Concierge TV.Remember, when screwing RF cables onto jacks, clockwisetightens, and counterclockwise loosens.No A/V cables are included with the Zenith Concierge TV.Model H2539Y does not have the MPI card.InOut AudioVideo3 4VCR backVCR back AV paneloutputswitchRF coaxial wire(75ohm)not includedwith TVA/V cablesnot includedwith TVTV back panel(expanded view)VIDEOINANTENNACABLEM.P.I.SuperPort SPEAKEROUTAUDIOINTV backFlat wire(300 ohm)Antenna300/75 ohmAdapterInOut AudioVideo3 4VCR backVCR back AV paneloutputswitchRF coaxial wire(75ohm)not includedwith TVA/V cablesnot includedwith TVTV back panel(expanded view)VIDEOINANTENNACABLEM.P.I.SuperPort SPEAKEROUTAUDIOINTV backRF coaxial wire(75ohm)AntennaLocate the Antenna/Cable jack on the back of the VCR.Connect the cable that runs from the antenna directly tothis jack, according to the diagram to the right.Remove the back of the remote and put in two AA batter-ies.Plug in the TV. Do not plug it into a switched outlet. TheConcierge TV is designed to operate on standard current,120-volt 60 Hertz AC. Do not attempt to operate it on DCCurrent.Go to page 11 to Auto Program the Concierge TV.back ofremote12345