Zenith H25F36DT Installation And Operating Manual, Warranty

P A G E 1 7206-3751Setting Add/Delete/Blank12345TIMERCH PREVIEWENTER1 2 34 5 67 8 90POWERFLSHBKMUTEVOLUMECHANNELTV/FMCCMENU ALARMADJ ADJSELECT2CH 44 ADDEDAUTO PROGRAMADD/DEL/BLNKCH. LABELSCLOCK SETTIMERCAPTIONSLANGUAGESETUP MENU43/5133Fine-tune the guest’s channel selection listPress the MENU key on the Installer’s remote so the Setupmenu appears.Press SELECT repeatedly to highlight the Add/Del/Blnkoption.Using either the NUMBER keypad and ENTER or theChannel Up/Down arrow on the remote, select a channel.(If adding a deleted channel, you will need to use theNUMBER keypad and ENTER.)Using the Right/Left ADJ arrow, specify whether thatchannel is Added, Deleted, or Blank.To continue, select another channel and repeat Step 4.When you are finished, press ENTER to remove menu.Adding Aux, VCR 3, VCR 4, to the ChannelPreview ListGo to the Setup menu, select the Add/Del/Blnk option.Use Channel Up/Down to select the option and chooseAdded.Note: If the option was turned off in the Service menu,you will have to reinstate it before it can appear as anoption in the Channel Preview list.Note: You can specify Add, Delete or Blank for VCR3,VCR4, and Aux. Caution: If you delete CH3, VCR3 is alsodeleted, if you delete CH4, VCR4 is also deleted and viceversa.If you delete a channel, it isn’t gone for good. Just select it usingthe NUMBER keypad on the remote, or add it later.Mini glossaryADD Adds new channels to the list that the guest can scroll through when using the remote.DELETE Removes channels for one reason or another from the list that the guest can scroll through.BLANK Removes the video signal from a channel so the guest will only receive the audio signal.