Zenith H25F36DT Installation And Operating Manual, Warranty

P A G E 3 5206-3854You may opt for TV channels only; TV channels + Off/ON withthese settings for Scan Mode:Scan mode Characteristics0 Channel up/down keys change channels only.1 Channel down below the lowest channel (orchannel up higher than the highest) and TVturns off.14-I. STRT CH IN SMWhen set to 1, installs TV on/off event below the start channelat TV turn on.15-I. SLEEP TIMERWhen set to 1, the SLEEP TIMER feature may be used (but nomessage is displayed prior to turn-off). When set to 0, the sleeptimer is not available.16-I. EN. TIMERSet to 1, timer function is available to user. Set to 0 to disableTimer functions. (Clock must be set in order to use Timers.)17-I. ALARMGives you the option of making the alarm function available tothe user. Set to 1, alarm function is available to user. Set to 0 todisable the Alarm function.Note: Clock must be set in order to set the Alarm.18-I. NOT USED19-I. NOT USED20-I. FEATURE LEVELDefault set to ZEN 1 for Zenith IR remote control operation.Set O, P LBL for Zenith Private Label IR remote con-trol operation. Warning: Do not set to “0” or remotewill not control TV.21-I V-CHIPSet to 1 to activate V-Chip (Parental Control); have it availableto user to filter or control or restrict programming content. Setto 0 to turn V-Chip feature off, not available to user; no pro-gramming restrictions can be set.22-I. MAX BLK HRSSet to 0 to 99 for the maximum V-Chip (Parental Control) blockhours. Default is 12 blocking hours.23-I. CAPTION LOCKSet to 1 to restore previous caption On/Off state after TV turnsoff. When set to 0, captions are always off, when TV is initiallyturned on.24-I. TEXT MODEDetermines whether TEXT 1, TEXT 2, TEXT 3, or TEXT 4 decodingis enabled when TEXT is turned on (either from the Setup Menuor directly with CC on the remote).TIP: Set Text Mode to 1 only if text is offered in your videosystem.25-I. FUNCTION PRE.Set to 0 to suppress CHANNEL PREVIEW from the FUNCTION menuwith some Pay-Per-View systems.26-I. NOT USED27-I. NOT USED28-I. CH. OVERRIDE (Channel Override)When set to 1, the user can select channels with either ChannelUp/Down or by direct keypad entry. When set to 0, only thosechannels that are entered for scanning may be selected by directkeypad entry. Note: If set to 0, Auto Program is locked; (asshown on Setup menu) you cannot do a channel search.29-I. OLD OCV (On Command VideoTM)Set to 1 for operation with systems from On CommandCorporation.30-I. ACK MASKM.P.I. Communication Parameter. Leave at default setting unlesschanged by Pay-Per-View provider.Installer menusInstaller Menu Items 14-I through 30-I: Detailed DescriptionsInstaller should leave item 20-I. FEATURE LEVELset to 1 (default).