Zenith PV4663RK Operation Manual & Warranty

Also see for PV4663RK: Operating guide & warranty

Zenith PV4663RK Operation Manual & Warranty Manual pdf 21 page image

REMOTE CONTROL MODEL MBR3430PREPARATION FOR USEBatteries are provided with this remote, but you must installthem before using the remote.INSTALLING BATTERIESWhen the effective operating range of your remote becomesnoticeably shorter, replace the batteries with two high-quality,alkaline, size AAA batteries.Zenith is not responsible for damage caused by batteryleakage.After installing new batteries, the remote control will set itselfto Zenith brand codes, as follows: TV=101, VCR=201 andCABLE=301.If you are going to operate equipment that uses differentcodes, the remote must be reprogrammed for those codes.AUTO FIND MODEUse Auto Find to automatically find the brand code needed tooperate your equipment.NOTE: If no button is pressed for 60 seconds or more duringAuto Find, the remote will automatically exit Auto Findwithout storing any brand codes. (LEDs will flash 3 timesupon exiting.)1. Turn on the equipment you wish the remote to oper-ate.2. Press and hold LEARN until mode indicator lights(about 4 seconds).3. Use MODE to select the mode you wish to program(TV, VCR or CABLE).4. Enter "00" then press ENTER within 2 seconds. All fourmode indicator lights will turn ON and then OFF, leavingthe mode indicator light for the active mode ON.5. Point remote towards the equipment.6. Press and release OFF/ON on the remote about once everysecond, until the equipment turns OFF. Press ENTERbefore pressing any other buttons.If you press OFF/ON again before pressing ENTERAuto Find will have to be repeated.7. Try other buttons to see if they operate the equipment.lfthey do not, you may wish to reenter Auto Find andtry to find another code. The remote will begin withcodes starting from where it left off prior to exitingAuto Find.CABLE-TV DECODERLCHANNEL_]LN8. Repeat Auto Find for each piece of equipment you wantyour remote to operate. NOTE: Only one brand code canbe programmed in each of the four modes.If no brand code has been entered after searching through allbrand codes in any mode, the remote will flash all four modeindicator lights in a chasing manner. Wait 60 seconds or pressENTER or LEARN to return to normal operation.2736-0 4--5