Zenith Z44SZ80 Installation And Operating Manual

Also see for Z52SZ80: Specifications Service manual Installation and operating guide Service manual Service manual

Owner’s Manual 39Programming the RemoteProgramming the RemoteProgramming the Remote1. Test your Remote Control.To find out whether your remote control can operate the devicewith out programming, turn on the device such as a the VCRand press the corresponding mode button (VCR) on the remotecontrol while pointing at the device. Test the POWER andCH +/- buttons to see if the device responds properly. If not, theremote requires programming to operate the device.2. Turn on the device to be programmed. Then press the corresponding mode button on the Remote Control.3. Press the POWER button and the MUTE button simultaneously. Now the Remote Control is ready to program thecode for the corresponding device.4. There are two ways to find the right code for the device.A. If you press the CH +/- buttons repeatedly, the codes willchange one at a time. Press the POWER button after eachcode change. If the right code is found, the device will turn off.B. Enter a code number using the number buttons on the RemoteControl. The right code numbers for the corresponding compo-nent can be found on the following pages.Again, if the code is correct, the device will turn off.5. Press the EXIT button to store the program.6. Test the Remote Control functions to see if the deviceresponds properly. If not, repeat from step 2.1 2 34 5 67 8 90TVMODE LIGHT POWERTV/VIDEO INFOSLEEPVCR CABLE DVD SATMUTESWAPPIPCH- PIPCH+PIPRATIORECORDSTOPPAUSEREWPLAYFFMENU EXITCC FREEZE PIP INPUTVOL CHFAVSAP ADJUSTEZ SoundEZ VideoTV INPUTSKIPFLASHBK+-24534The Remote Control for your HD receiver is a multi-brand or universal Remote Control that canbe programmed to operate most remote-controllable devices of other manufacturers.Note: The Remote Control may not be able to control all models of other brands.3