Zennio Z41 Pro User Manual
Also see for Z41 COM: Configuration guideConfiguration guideHow to configureTechnical documentation
                                                                                                                                                                         | |
Contents
| 
Z41 Pro / Lite / COMhttp://www.zennio.com Tecnical Support: http://support.zennio.com543.2.4 SCREENSAVERAfter enabling “Screensaver” from “General” screen (see section 3.2.1), a new tab willbe incorporated into the tree on the left.Figure 40 Screensaver (Main Configuration)This screen contains the following parameters:Activation timeout: time to automatically show the screensaver after the lastbutton touch. Range: 1 – 255 seconds, minutes or hours.Attenuate Display: sets whether to decrease the display brightness whenshowing the screensaver.Time/Date: sets whether to show the current time or not.Temperature: sets whether to show the current temperature or not. Whenenabled, the following parameter will show up:➢ Taken from: defines the source of the temperature value: “Internal sensor”or “External reference”. The latter will bring a new two-byte object to theproject topology (“[General] External Temperature”) so that through it thedevice can receive the values from the bus.Image: sets whether to show the screensaver image (see section 2.5).Note: The Screensaver will not appear if the Welcome Greeting is shown. |
Related manuals for Zennio Z41 COM
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine