Zippie VOYAGE Owner's Manual
Also see for VOYAGE: Owner's manualOwner's manualQuick guide
                        | |
Contents
| 
124267 Rev. B 16ENGLISHIXCushion types1. Standard (A), ledge (B), and wedge (C)2. Each type of cushion effects the child’s posture in a different and specific way.3. Be sure to consult your health care advisor before changing the type of cushion.D. ADJUSTABLE CONTOUR CUSHION ADJUSTMENTSThe contoured seat cushion comes in three seat lengths, short, medium, and long. The shortseat is 5" long, the medium seat is 7", and the long is 9”. These cushions can be grown by anadditional 3” by adding a 3" growth strip at the back of the cushion. The front and rear sec-tion of the cushion (D) has Velcro® attachment points for positioning the adductor wedgesprovided. They attach to the front and rear section of the cushion under the foam overlay.The foam overlay attaches to Velcro® at the back of the seat.Adding growth strips1. Unzip seat cover and fold the top over the front edge to expose the cushion.2. Lift the foam overlay piece away from the Velcro® attachment, using care not to tearthe foam.3. Grasp the rear foam section at the middle and lift it from the velcro attachment.4. Add either the 2" or the 3" growth strip at the back of the front foam section assuringthat the angled edges and sides align, and black foam is facing down.5. Re-attach the rear section assuring the angled edges and sides align.6. Adjust the adductor wedges as needed and position the foam overlay over the cushionand attach to the Velcro® at the rear of the seat.7. Close the zipper around the cushion and install into the unit.Cleaning the seat cover1. Unzip the cover (E) along the edge.2. Remove the cushion assembly from the Velcro® attachment inside the cover.3. The fabric seat cover should be hand washed with laundry soap, thoroughly rinsedwith clean water, and air dried.4. The foam cushion pieces may be wiped down with soap and water. Always be surethey are completely dry before replacing the fabric cover.5. Place the cushion into the fabric cover and onto the Velcro® with the front edge ofthe cushion aligned with the front edge of the cover.6. Pull the cover over the cushion and close the zipper around the cover.E. STANDARD PLANAR CUSHION WITHOUT LATERAL SUPPORTSAdding growth stripsThe standard cushion without lateral hip supports comes in three seat lengths, short,medium, and long. The short seat is 8" in length, the medium seat is 10", and the Longis 13”.F. SHOULDER STRAP HEIGHT ADJUSTMENT1. Open the exterior back panel cover from the rear of the device to expose the backgrowth slots, and adjustment screws.2. Loosen, do not remove (4), screws (F) through the access holes behind the back plateon each side. Adjust shoulder strap bar to proper height. Tighten all of the adjustmentscrews to 45 in-lbs (do not overtighten) and then re-adjust the shoulder straps for acomfortable fit.2627282926A28E2729DCBF |
Related manuals for Zippie VOYAGE
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine