Zippie VOYAGE Owner's Manual
Also see for VOYAGE: Owner's manualOwner's manualQuick guide
                        | |
Contents
| 
124267 Rev. B 20ENGLISHIXForehead Strap Adjustment1. Using an Allen wrench: Loosen the guide rods adjustment screws (A) and slide bothguide rods evenly to desired diameter.2. Locate neoprene strap in desired position on forehead.3. Slide guide rods through clamp until front of neoprene strap is approximately 1/2”from plastic guide support. Strap must fit snuggly on forehead.4. Re-tighten guide rod adjustment screw (A) to hold position.5. Guide rods may be trimmed to 1” limiting rearward protrusion.Vinyl caps should beremoved prior to trimming and then reinstalled.6. Re-adjust forehead strap as necessary.Headrest Downward Stop Angle Adjustment1. Using an Allen wrench loosen the angle adjustment clamp screws (B)2. Insert an Allen wrench into the exposed hole on the silver angle adjustment pivot (C)and rotate until the forehead pad and guide rods are at the desired angle.3. Re-tighten the angle adjustment clamp screws and check all settings.NOTICE– Fasteners and DFS2 adjustment should be checked prior to each use. Neoprene Strap mustbe replaced at the first signs of wear or loss of tension. Please refer to Headstrap instructionsheet on the website or in your kit.N. LATERAL HIP BLOCKS (OPTIONAL)Hip pads are optional equipment available only with the optional contoured seatingsystem.Width Adjustment1. Determine the proper location for each hip pad.2. Remove the back cushion to expose hip pad adjustment screws.3. Loosen two adjustment screws for each hip pad just enough to allow adjustment.4. Adjust hip pads to the desired position.5. Tighten the adjustment screws and replace the back cushion.NOTE– Hip pad hardware must be removed for hip widths greater than 10". The foam hip padattaches beneath fabric at back pivot point to accommodate an 11" hip width.O. MEDIAL SUPPORT PADS (OPTIONAL)Medial support pads are optional equipment available only with the optional con-toured seating system.Angle and Width Adjustment1. Locate medial adjustment screw. (D) Screw is located beneath the forward edge of theseat. Seat cushion removal aids greatly in finding screw location.2. Lock the wheels, seat the child, and buckle the pelvic positioning belt.3. Loosen the adjustment screw from beneath the seat and adjust medial pad to properwidth and angle.4. Tighten adjustment screw to lock the medial position.5. If using 2 pads, repeat the adjustment sequence on opposite side.39394039ACB40D |
Related manuals for Zippie VOYAGE
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine