iiNet BOB2 User Manual
Also see for BOB2: User manualSetup guideQuick installation guideHandset manualQuick start guide
                 | |
2926 Customer SupportCustomer SupportOur friendly support team is available 24/7 on 13 22 58 or via email at support@iinet.net.au.Stuck? Here’s a quick fix guide for some common hiccups.The display is blank:• The handset is not switched on.• Press and hold the end call key .The batteries are flat:• Charge or replace the batteries“Base x” flashes on the display:• The handset is outside the range of the basestation.• Move the handset closer to the base station.• The base station is not switched on.• Check the base station mains adapter.“Please register” flashes on the display:• Handset has not been registered with theBoB2TM modem.• Register the handsetHandset does not ring:• The ring tone is turned off• Activate the ring toneBattery DisposalCAUTIONRISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE.DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.Correctly disposing of batteriesBatteries should not be disposed of in general household waste. Observe local waste disposal regulations – which canbe obtained from your local authority. All electrical and electronic equipment must be disposed of separately fromgeneral household using the sites designated by local authorities.The appropriate disposal and separate collection of used equipment serve to prevent potential harm to theenvironment and to health. They are a precondition for the re-use and recycling of used electrical and electronicequipment.Battery Disposal |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine