red lion N-Tron Series Hardware Manual

red lion N-Tron Series Hardware Manual Manual pdf 54 page image

Revised 2019-08-22 Hardware InstallationDrawing No. LP0988 Mounting the Unit2-40 N-Tron® Series 700/7000 Managed Industrial Ethernet Switch Hardware Manual - Volume I2.3.3 DIN‐Rail Removal Instructions From Vertical MountingRemove the switch from standard 35mm DIN-Rail as shown in the diagram above.1. Ensure power from the power source is off.2. Disconnect power and ground wires.3. Disconnect any communications cables from the unit.4. Insert a standard flat/slotted screwdriver into the slot provided on the DIN-Rail clip.5. Using the base of the switch as a pivot point, apply upward force on the screwdriver to release the DIN-Railclip.6. With the DIN-Rail clip latching mechanism released, continue to rotate the switch upward and away from thepanel.7. Once the switch has been rotated upward, remove the screwdriver.Carefully lift the switch upward and away from the DIN-Rail and panel.2.3.4 Bulkhead Mounting 708M12 and 716M12 ModelsThe 708M12 and 716M12 models are designed for bulkhead mounting or within an enclosure and are IP67 rated.There are optional Din-Rail mounting kits with metal or plastic clips available. This section includes the mechanicaldimensions and drill hole placements to consider when bulkhead mounting the unit. Allow at least 3” of horizontalclearance in the installation location for copper cable bend radius.