red lion N-Tron Series Hardware Manual

red lion N-Tron Series Hardware Manual Manual pdf 61 page image

N-Tron® Series 700/7000 Managed Industrial Ethernet Switch Hardware Manual - Volume I 2-47Hardware Installation Revised 2019-08-22Connecting the Switch Drawing No. LP09882.6.2 708TX, 708FX2, 716TX, 716FX2, 7018TX and 7018FX2 Model Serial InterfaceThe 700/7000 switch models provide an EIA-232 interface accessed via a DB9-pin female connector (labeled‘COM’ on the unit). This is used to access the Command Line Interface (CLI). The pin-outs are shown below.2.6.2.1 Serial Cable ConnectionConnect the serial COM port of your PC and the 700/7000 model switch using a standard straight through serialcable. You will require a cable with a 9-pin or 25-pin sub-D female connector for the PC end, and a 9-pin malesub-D connector for the 700/7000 switch model end.The following table shows the pin-out and the connections for both types of cable:2.6.3 Connecting the 708M12 and 716M12 ModelsThe 708M12 and 716M12 Industrial Ethernet Switches are fully protected against dust and will remain sealed whenimmersed in water to a depth of 1 meter for 1 hour when all the ports are properly mated or sealedFor 708M12 and 716M12 units, remove the IP67 cap from the M12 port connectors and connect the Ethernetcables. These IP67 caps seal off the unused ports protecting them from dirt, water, oil or any other contaminantswhich might be present in close proximity of the switch.PC Port 25-Pin Female 9-Pin Female 7xx Model 9-Pin MaleSignal Name Pin # Pin # Pin # Signal NameTXD 2 3 3 RXDRXD 3 2 2 TXDGND 7 5 5 GND