u-blox ODIN-W260 System Integration Manual

u-blox ODIN-W260 System Integration Manual Manual pdf 24 page image

ODIN-W2 series - System Integration ManualUBX-14040040 - R03 Advance Information Qualifications and ApprovalsPage 24 of 334 Qualifications and ApprovalsThe ODIN-W2 series modules are in Advance Information status as mentioned in Document statusexplanation section. Hence, the following information is not fully valid and completed yet but willbe when the module is fully tested and approved in the Production Information stage asmentioned in the Document status section:• Safety Compliance• FCC and IC Compliance• Japan Radio Equipment ComplianceThe required action needed by the module integrator is described in this chapter. For a complete description ofthe qualifications and approvals see the ODIN-W2 series Data Sheet [2].4.1 Safety ComplianceIn order to fulfill the safety standard EN 60950-1 the unit must be supplied by a limited power source.4.2 FCC and IC compliance - Labeling Requirements for End ProductThe ODIN-W2 series modules are in Advance Information status as mentioned in Document statusexplanation section. Hence, the following information is not fully valid and completed yet but willbe when the module is fully tested and approved in the Production Information stage asmentioned in the Document status section:For an end product using the product cB-0965 there must be a label containing, at least, the followinginformation:This device containsFCC ID: PVH0965IC: 5325A-0965The label must be affixed on an exterior surface of the end product such that it will be visible upon inspection incompliance with the modular approval guidelines developed by the FCC.In accordance with 47 CFR § 15.19 the end product shall bear the following statement in a conspicuous locationon the device:"This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions;(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesiredoperation."When the device is so small or for such use that it is not practicable to place the statement above on it, theinformation shall be placed in a prominent location in the instruction manual or pamphlet supplied to the useror, alternatively, shall be placed on the container in which the device is marketed. However, the FCC ID labelmust be displayed on the device.In case, where the final product will be installed in locations where the end-user is not able to see the FCC IDand/or this statement, the FCC ID and the statement shall also be included in the end-product manual.