u-blox ODIN-W260 System Integration Manual

u-blox ODIN-W260 System Integration Manual Manual pdf 25 page image

ODIN-W2 series - System Integration ManualUBX-14040040 - R03 Advance Information Qualifications and ApprovalsPage 25 of 334.3 UL listing informationThe ODIN-W2 series module is under development currently and more information will be available whenthe module is fully tested and approved.4.4 Japan Radio Equipment Compliance - Labeling Requirements for EndProductThe ODIN-W2 series modules are in Advance Information status as mentioned in Document statusexplanation section. Hence, the following information is not fully valid and completed yet but willbe when the module is fully tested and approved in the Production Information stage asmentioned in the Document status section:When a product integrated with an ODIN-W2 module is placed on the Japanese market, either must:• the ODIN-W2 module be affixed with a label with the Giteki marking below.In this case is it recommended that the product is marked with “Contains MIC ID: R 204-510009”.• the product be affixed with a label with the Giteki marking below. The marking must be visible forinspection.204-510009この製品は屋内においてのみ使用可能ですFigure 9: Giteki mark, R and the ODIN-W2 MIC certification number. The “Indoor use only” information translated intoJapanese below is mandatory if the product is operating in the 5.2/5.3 GHz band.The recommended size of the Giteki mark is Ø5.0 mm but the minimum size is Ø3.0 mm.The end product holder should also include a copy of the Japan Radio Certificate to the end product technicaldocumentation. Contact support@u-blox.com for a copy of the Radio Certificate.4.5 Compliance with RoHS directiveThe ODIN-W2X product is produced according to the RoHS (Restriction of the use of certain HazardousSubstances in electrical and electronic equipment) directive and complies with the directive.